成人无码高潮av在线观看_欧洲极品少妇_夂久亚州精华国产精华华液_在线观看亚洲AV每日更新无码_亚洲国产精品无码久久一线_亚洲精品区午夜亚洲精品区

IP211-X15-ISF_IP211-X27-ISF_IP211-X15-ISC電動氣動傳感器OMEGA

低成本

內置增壓器

小尺寸

場可逆

低耗氣量

以任何角度安裝

方便的外部跨度和零位調整

（防爆型除外）

寬供氣壓力范圍

供氣壓力敏感度低

回路供電

IP211-X15-ISF_IP211-X27-ISF_IP211-X15-ISC電動氣動傳感器OMEGA

Low Cost

Built-in Volume Booster

Small Size

Field Reversible

Low Air Consumption

Mounts at Any Angle

Convenient External Span and Zero Adjustment 

(Except for Explosion Proof Models)

Wide Supply Pressure Range

Low Supply Pressure Sensitivity

Loop Powered

The IP211/EP211 Series transducer is an electropneumatic device that reduces a supply pressure to a regulated output pressure directly proportional to an electrical input signal. The 211 Series accepts a wide range of supply pressures, ranging from a minimum of 3 psig (0.2 BAR) above the maximum output up to 100 psig (6.9 BAR). An integral pneumatic volume booster is included in the design to provide high flow capacity (up to 12 SCFM). Model selection includes General Purpose, FM Intrinsically Safe, and CSA Intrinsically Safe.

Mounting

These transducers can be pipe, panel, or bracket mounted in any position. Positions other than verticle will require recalibration of the zero adjustment. For maximum output stability the transducers should be mounted in a vibration free location or such that vibration is isolated in the X and Z axis.

Field Reversible

All transducers are calibrated at the factory for direct acting operation but may be used in the reverse acting mode by reversing the polarity of the signal leads and recalibrating. When recalibrated for reverse acting applications, the transducers provide a minimum of their full rated output pressure (i.e.15, 27, or 30 psig) upon input signal failure.

IP211-X15-ISF_IP211-X27-ISF_IP211-X15-ISC電動氣動傳感器OMEGA

安裝

這些傳感器可以安裝在任何位置的管道、面板或支架上。垂直以外的位置需要重新校準零點調整。為了獲得***大的輸出穩定性，傳感器應安裝在無振動的位置，或在X和Z軸上隔離振動。

場可逆

所有傳感器都在工廠進行了直接作用操作的校準，但可以通過顛倒信號線的極性和重新校準在反向作用模式下使用。當為反向作用應用重新校準時，傳感器在輸入信號故障時提供***小的全額定輸出壓力（即15、27或30磅/平方英寸）。